ブログ

Learn how to choose a trusted SMT supplier using IPC, ANSI/ESD, IEC, traceability, capacity, and total-cost checks for reliable surface mount manufacturing.

Line-side staging works when the ESD box has a defined place, a defined owner, and a defined next step. The buyer should map the handoff...

An ESD storage box and an ESD circulation box may look similar, but the buyer decision is different. A storage box protects an identified item...

A galvanized-base ESD magazine rack should be specified through the conditions at the floor, not through a coating label alone. Describe where the rack sits,...

An ESD magazine rack with a whole-panel arrangement should be reviewed as a board-handling system, not selected from its appearance alone. Start with the board...

A B2B ESD packaging RFQ is reviewable when it describes the item, handling route, quantity band, and acceptance evidence together. A generic request for “ESD...

Choose replacement when the approved box design still fits the work. Choose a tooling review when the required geometry, interface, or controlled handling condition has...

A replacement-part RFQ starts with the rack, not the spare part. Record the rack model, frame dimensions, guide interface, base type, sheet and slot arrangement,...

“ESD safe” and “ESD protected” are not complete specifications. A buyer should connect either phrase to the handling step, the protected-area boundary, the package or...

End-to-end PCB storage and handling becomes easier to control when each carrier has one primary job. Use a rack to separate boards, a tray to...

Conductive foam is not automatically a complete IC-protection system. It may provide a shaped contact, cushioning or a controlled discharge path. A grounding wire is...

An ESD bag and a static-shielding tote are not interchangeable names for the same package. Start with the job: a bag usually contains one unit...